Decorative Concrete Plaster For Walls | Concrete Effect

1. The substrate must be stable, dry, and free of dirt, separating agents, and unevenness.
2. Sand off any unevenness.
3. Mix CONCRETE EFFECT powder with water in a ratio of 5:2 by weight (e.g. 1kg EFFECT powder with 400ml water).
4. Add approx. 2% WB PIGMENT․
5. Apply material with a trowel. Working Time: Approx. 30min. Consumption Volume: approx. 1kg/m² per 1mm layer thickness. Drying Time: approx. 24hrs

For wet rooms, surfaces with direct water contact, as well as heavily used surfaces (high mechanical load, cleaning with aggressive cleaning agents, etc.), we recommend sealing the surface with EPODEX Polyurethane Resin (PU Finish) in matte.

1. To mix, pour the entire contents of PU Finish Component B into the container of PU Finish Component A and mix thoroughly.
2. Apply the material thinly and in a crosshatch pattern using a paint roller and brush. First paint laterally to the light source, then wet-on-wet in the direction of the light to avoid visible brush marks.
   Important: Especially inside the shower and in areas with permanent water contact, we recommend applying our PU Finish exclusively with a brush (e.g. 10 cm width) in a crosshatch pattern to fully close all pores. For heavily textured surfaces outside the wet area, a brush should also be used (and not a paint roller). We recommend two coats.
3. Allow the material to cure for at least 16 hours, then apply the second coat.
4. Allow the material to cure for 48 hours after the second coat. Inside the shower and in areas with permanent water contact, allow 7 days to cure before the coating comes into contact with water.