Exposed Concrete Finish Set with Exposed Concrete Film

1. The substrate must be stable, dry, and free of dirt, separating agents, and coarse unevenness.
2. Sand off any unevenness.
3. Apply Primer:
   • For wall tiles, we recommend priming the tiles and joints with our special primer & putty and filling the joints with it.
   • For walls and floors without tiles, we recommend using our Deep Primer
   • All primers can be found under the Accessoriesbutton on this product page.
4. Allow the primer to dry.

1. Mix the Microcement A-component in medium grain with the LIQUID B in a 5:1 mixing ratio, e.g. 7kg of Microcement Powder (A) with 1.4kg of acrylic resin LIQUID B.
2. Add the supplied WB pigment to colour the material. Use approximately 2% WB pigment, e.g. 2x 100g bottles for 7kg of Microcement powder and 1.4kg of acrylic resin.
3. Spread the material onto the wall with a trowel. Consumption Volume: approx.1.2kg/m².
4. Moisten one side of the exposed concrete film with a water spray bottle and apply the film to the wall. Press the film firmly with a trowel.
5. Allow the material to dry. Drying time at 20°C: 24 hours.
6. Once dry, peel off the film<

Note: For damp rooms, surfaces in direct contact with water and heavily used surfaces (high mechanical stress, cleaning with aggressive cleaning agents, etc.), we recommend sealing the surface with EPODEX polyurethane resin (PU resin).

1. Mix PU resin and hardener in the specified mixing ratio and pour into a paint tray.
2. Apply the material thinly with a foam roller in a crosswise motion and allow to harden. We recommend two coats.
    

1. The substrate must be stable, dry, and free from dirt, separating agents, and unevenness. The Concrete Effect can also be applied directly to tiles without the need for an additional primer.
2. Mix CONCRETE EFFECT powder with water in a 5:2 weight ratio, e.g. 1kg of powder with 400ml of water.
3. Add the supplied WB pigment to colour the material. Use approximately 2% WB pigment, e.g. 2x 100g bottles for 5kg of EFFECT powder and 2 litres of water.
4. Apply the material with a trowel. Working time: approximately 30 minutes. Consumption Volume: approx. 1kg/m² per 1mm layer thickness.
5. Moisten one side of the exposed concrete film with a water spray bottle and apply the film to the wall. Press the film firmly with a trowel.
6. Allow the material to dry. Drying time at 20°C: 24 hours.
7. Once dry, peel off the film.

Note: For damp rooms, surfaces in direct contact with water and heavily used surfaces (high mechanical stress, cleaning with aggressive cleaning agents, etc.), we recommend sealing the surface with EPODEX polyurethane resin (PU resin).

1. Mix PU resin and hardener in the specified mixing ratio and pour into a paint tray.
2. Apply the material thinly with a foam roller in a crosswise motion and allow to harden. We recommend two coats.